Products > Document library

Product Details
Back | Back To Search | Printable version


APVMA Code :60471
Active Constituent(s):
900g/kgatrazine
Registered For
Commercial Use Domestic Use

Overview A pre-emergent and post-emergent herbicide for the control of annual grasses and broadleaf weeds in a range of crops and Pinus radiata plantations and for use in triazine tolerant canola.
Chemical Group triazine
General Instructions This product can be used both pre and post emergent to selectively control weeds in the crops listed in the directions for use table and in Pinus radiata plantations. It can also be used to control weeds in Triazine Tolerant Canola varieties Established perennial species, large annual and large broadleaf weeds will not be controlled at the rates recommended. Duration and effectiveness of control depends on the amount of chemical applied, soil type, rainfall, weed species and other conditions.
Sufficient moisture (either rainfall or irrigation) is required to move the product into the root zone of weeds to make the product effective. This should occur within 10 days of application to ensure product effectiveness.
The maximum rate of application in all crops except forestry will be 3.0 kg ai per hectare per year (ie 3.3 kg product per hectare per year). The maximum rate in plantation forestry will be 4.5 kg ai/ha per year (5 kg product per hectare per year) in sandy soils and those defined as highly erodible, and 8 kg ai/ha per year (8.9 kg product per hectare per year) in clay loams and heavier textured soils.

Integrated Weed Management Strategy for TT Canola
The use of this product in TT canola is subject to the current 'Integrated Weed Management Strategy for the use of triazine herbicides in TT canola' The Strategy encompasses:
- Integrated Weed Management;
- the specific management of crop plant volunteers and outcrossing to other plants; and
- triazine herbicide residue management (agronomic and environment).
Compliance with registered label directions and adoption of the principles outlined in the Strategy will assist with implementation of crop management practices that minimise the development of herbicide resistance in treated weeds; reduce the levels of triazine residues in the environment; and manage volunteer plants and outcrossing.
Copies of the current Strategy are available from Sipcam representatives or by contacting Sipcam Pacific Australia Pty Ltd, Level 1, 191 Malop Street, Geelong VIC 3220.
Where specific information and farm management assessment is required to assist with application of Integrated Weed Management programs on-farm, particularly in adapting strategies to local conditions, then specific expert advice should be obtained from an appropriate agronomist, consultant, chemical supplier or Departmental adviser.
To minimise herbicide resistance:
- Avoid dry sowing in heavily weed infested paddocks. Wait for a weed germination after the opening rains in weedy paddocks. Use a pre-plant knockdown or cultivation. No weeds should be allowed to survive at this stage.
- Adapt the weed control program to the anticipated weed spectrum and pressure: Broadleaf Weeds and Ryegrass: Use Sipcam Simazine 900 WDG or Sipcam Atrazine 900WG plus trifluralin pre-emergence. A follow-up with a Group A herbicide (if ryegrass is susceptible) or Sipcam Atrazine 900WG may be necessary. Broadleaf Weeds only: Use Sipcam Atrazine 900WG post-emergence.
- DO NOT use Sipcam Atrazine 900WG or Sipcam Simazine 900 WDG if the area to be treated had a triazine herbicide applied to it last season.
- Watch for escapes, especially in paddocks with a long history of Group C herbicide use.
- DO NOT use Group C herbicides in consecutive years.
Resistant Weeds Reporting
Growers should collect plant or seed samples where weeds that are normally susceptible to atrazine and simazine may be resistant, get them tested and seek professional advice.
To avoid Triazine carry-over:
On acid soils (pH less than 6.5) - The maximum rate of Sipcam Simazine 900 WDG or Sipcam Atrazine 900WG or a combination of the two products to be applied to the crop during the growing season is 2.2 kg/ha.
On alkaline soils (pH greater than 6.5) - The maximum rate of Sipcam Simazine 900 WDG or Sipcam Atrazine 900WG or a combination of the two products to be applied to the crop during the growing season is 1.1 kg/ha.
Post-emergence use - It is recommended that Sipcam Atrazine 900WG only be used, and at rates of 1.1 kg/ha or less, on both acid or alkaline soils.

Mixing
Do not mix/load or apply within 20m of any well, sink hole, intermittent or perennial stream. Partially fill the spray tank with water and maintain agitation while adding the required quantity of Sipcam Atrazine 900WG. Ensure thorough mixing and agitate while spraying.
If spray is allowed to stand, agitate thoroughly before resuming spraying.

Compatibility
This product is compatible with 2,4-D Amine, diuron, paraquat and paraquat/diquat mixtures. It is advisable that a small scale compatibility test be carried out prior to tank mixing with other products. In sugar cane only, the addition of Sodium 2,4-D will assist in short term suppression of Nutgrass and other sedges.

Warning
Sorghum, Broom millet, Saccaline
Heavy rain immediately after application may result in excessive concentrations of herbicide in the seed furrow, encouraging crop injury. This is most likely to occur in pre-plant or pre-emergence applications using rates in excess of 2kg/ha. To avoid the likelihood of herbicide injury use technique (a), (b) or (d) in the Method of Application table.
Do not use as a pre-emergence application in the wet season in the northern irrigation areas of Western Australia. When sowing is made on the flat avoid application to ridged soil.
Applying the total amount of product as a pre-emergence application will increase the risk of crop injury in the event of heavy rain after application.
Maize, Sweet Corn
For post-emergent application add crop oil at the rate of 5.5L/ha if grass weeds are a problem. Ensure that the mixture is continually agitated. Do not apply mixtures of crop oil to stressed crops, inbred lines or breeding stock as injury may occur.
If only broadleaf weeds are a problem, add 135mL of a 100% non-ionic surfactant per 100L of spray mixture.

Application
Application can be made by low volume boom or by aircraft. (except in TT canola).
DO NOT use human flaggers in aerial spraying, unless protected by engineering controls such as enclosed cabs.
Suggested minimum volumes of spray mixture per hectare are:
Boom:
Pre-plant / Pre-emergence 55L
Post Emergence 110L
Air:
Pre-Plant/ Pre-Emergence 15L
Post Emergence 22L
Application can be made as an overall spray or as a band spray. Minimum band width should be 30cm.
TT canola - DO NOT apply to TT canola by aircraft. Apply only with a low volume boom sprayer with a 60m buffer zone downwind of treated fields to natural or impounded lakes or dams, and a 20m buffer zone for any well, sink hole, intermittent or perennial stream. Apply only to areas where run-off is unlikely to occur or where run-off may be captured by farm earthworks.
Incorporation (Pre-plant and at sowing application)
This product acts mainly by root absorption. Its effectiveness depends on the occurrence of rainfall or irrigation to move it down into the weed root zone. Sufficient rain or irrigation to thororouhly wet the soil through the weed root zone should occur or be made immediately after application to provide appropriate weed control. Delay in activation of this product may result in some weed growth. In flood or furrow irrigation situations complete and continued activation of the product due to a thin hard band of dry soil on the surface during or after irrigation. Mechanical incorporation after application, using light harrows to incorporate the product into the soil not more than 4 cm deep is required to ensure the irrigation water activates the product.
Always apply the product to an even unridged seedbed.
Method of Application
For dryland and irrigated Sorghum, Broom millet, Saccaline, Maize and Sweet Corn. See label.

Restraints DO NOT apply to waterlogged soil. DO NOT apply if heavy rains or storms that are likely to cause surface runoff are forecast within two days of application.
DO NOT irrigate to the point of runoff for at least 2 days after application. DO NOT use as a pre-emergence application in sorghum, broom millet, or saccaline during the wet season in the Northern Irrigation areas of Western Australia. DO NOT apply product to any drainage line. Drainage lines show evidence of the action of periodically flowing water (for example, gravel, pebble, rock or sand bed scour hole or nick point) and/or an incised channel at least 30cm deep. Do not handle, mix, apply or conduct testing operations in areas susceptible to runoff where drainage results in rapid entry into waterways, particularly where no specific and effective action has been taken to prevent runoff into waterways. These areas may include areas mounded perpendicular to the contour, roads, access tracks, snig tracks, and compacted log dumps. TT canola: DO NOT use or apply this product post-emergence on raised beds or where furrows have been created in the soil for the purpose or holding or channelling water.
SOIL MOISTURE: This product requires rainfall or irrigation to move it down into the weed root zone to make it effective. Sufficient rain or irrigation to thoroughly wet the soil through the weed root zone should occur or be made within 10 days after spraying.
Resistance Warning Sipcam Atrazine 900WG Herbicide is a member of the triazines group of herbicides. Sipcam Atrazine 900WG Herbicide has the inhibitor of photosynthesis at photosystem II mode of action. For weed resistance management Sipcam Atrazine 900WG Herbicide is a Group C Herbicide. Some naturally occurring weed biotypes resistant to Sipcam Atrazine 900WG Herbicide and other Group C herbicides may exist through normal genetic variability in any weed population. The resistant individuals can eventually dominate the weed population if these herbicides are used repeatedly. These resistant weeds will not be controlled by Sipcam Atrazine 900WG Herbicide or any other Group C herbicide. Since the occurrence of resistant weeds is difficult to detect prior to use, Sipcam Pacific Australia Pty Limited accepts no liability for any losses that may result from the failure of Sipcam Atrazine 900WG Herbicide to control resistant weeds. Any incidents of resistance must be reported to Sipcam Pacific Australia Pty Ltd.
Protection of wildlife, fish, crustaceans and environment DO NOT mix/load or apply product within 20m of any well, sink holes, intermittent or perennial streams or river. DO NOT apply this product within 60m of natural or impounded lakes or dams. DO NOT use in channels or drains. DO NOT apply under meteorological conditions or from equipment which could be expected to cause drift of this product or spray mix into adjacent areas, particularly wetlands, waterbodies or watercourses. DO NOT contaminate streams, rivers or waterways with the chemical or used containers. This product is very highly toxic to algae and aquatic macrophytes.
Protection of crop, native and other non-target plants Do not spray foliage of desirable plants. Do not apply high rates of application to heavier soils if roots of desirable shrubs and trees are near the surface. Do not use in channels or drains. Do not use near newly planted shrubs, young ornamentals or species with shallow roots eg Prunus species or trees in sandy porous soils. Do not apply under weather conditions or from spraying equipment that may cause spray to drift onto nearby susceptible plants/crops, cropping land or pastures. Do not apply or drain or flush equipment on or near desirable trees or other plants or on areas where their roots may extend or in locations where the chemical may be washed or moved into contact with their roots. Do not plant crops other than those recommended on this label for at least 6 months following treatments at rates up to 1.4 kg per hectare and for 18 months following treatments of 1.4 kg to 2.7 kg per hectare. Do not apply in excess of 3.3 kg product/Ha in any one year, except in forestry situations.
Protection of livestock When treating native pasture, keep stock off for 14 days while this product takes effect.
Safety Directions Avoid contact with eyes and skin. Do not inhale dust or spray mist. When preparing spray and using the prepared spray wear cotton overalls buttoned to the neck and wrist (or equivalent clothing) and a washable hat and elbow length PVC gloves. If using a hand directed sprayer, wear, in addition, waterproof trousers and boots. After use and before eating drinking or smoking, wash hands arms and face thoroughly with soap and water. After each days use, wash gloves and contaminated clothing.
FirstAid If poisoning occurs, contact a doctor or Poisons Information Centre (PHONE AUSTRALIA: 13 11 26)
Storage Store in the closed, original container in a dry, cool, well ventilated area out of direct sunlight.
Disposal Shake empty bag into spray tank. Do not dispose of undiluted chemicals on site. Puncture or shred and bury empty containers in a local authority landfill. If no landfill is available, bury the container below 500 mm in a disposal pit specifically marked and set up for this purpose clear of waterways, desirable vegetation and tree roots. Empty containers and product should not be burnt.
Precautions Re-entry period
Do not enter treated areas without protective clothing until spray has dried.


Product details last updated on 14 Dec 2016

DISCLAIMER: This is not the ATRAZINE 900WG label. To view or print the label for this product, click the "SDS/Label" tab at the top of this page. Always follow label instructions.

For specialist advice in an EMERGENCY only phone +61 1300 130 633, TOLL-FREE, ALL-HOURS, NATIONWIDE