||For control of broadleaf weeds in Cereals, Linseed, Pastures, Rice, Sugar Cane and Turf.
||Weeds should be sprayed while actively growing and at their most susceptible stage. As a general guide, annuals should be sprayed when young and perennials just prior to appearance of bud stage. Extremes of cold or drought are unfavourable. The best conditions are when the soil is moist, weather fine and rain unlikely within 6 hours following application. DO NOT spray crops or weeds outside the stages indicated in the Critical Comments, as damage, loss of yield or inadequate weed control may result. DO NOT spray in high winds.|
The use of MCPA is preferred to 2,4-D amine (amicide) or ester (estercide) in situations where Legumes are undersown in the crop.
Note: The tolerance of pasture Legumes to applied product can vary with species, variety , growing conditions, stage of growth and companion crop cover. DO NOT spray cereal crops undersown with Lucerne as damage may result.
This product mixes readily with water. Half fill the spray tank with clean water and add the required amount of product. Agitate thoroughly before adding the remaining water.
Boom spray: Use 30-120 L water/ha. Use minimum of 170 L water/ha for Linseed.
Aerial spray: Use 10-90 L water/ha.
Equipment that has been used for this chemical should not be used for the application of other materials to sensitive plants unless it has been well washed out with a 2% solution of cloudy ammonia followed by several clear water rinses.
This product can be tank mixed with clopyralid, dicamba, diquat, diuron, metsulfuron-methyl, paraquat, picloram, sethoxydim and terbutyrn. The effectiveness of dimethoate, oxydemeton methyl and phosmet and may be reduced by alkaline hydrolysis if tank mixed with the product. For these situations the addition of a surfactant (350 g/L soyal phospholipids + 350 g/L propionic acid) is recommended. When tank mixing add the required amount of compatible product (and surfactant if recommended) when the spray tank is nearly full and while continuously agitating. If left overnight, agitate thoroughly before spraying.
||DO NOT apply if crop or weeds are stressed due to dry or excessively moist conditions.
DO NOT apply if rain is likely within 6 hours.
||SIPCAM AGROXONE 750 Herbicide is a member of the phenoxy group of herbicides. SIPCAM AGROXONE 750 Herbicide has the disruptor of plant cell growth mode of action. For weed resistance management SIPCAM AGROXONE 750 Herbicide is a Group I herbicide. Some naturally occurring weed biotypes resistant to SIPCAM AGROXONE 750 Herbicide and other Group I herbicides may exist through normal genetic variability in any weed population. The resistant individuals can eventually dominate the weed population if these herbicides are used repeatedly. These resistant weeds will not be controlled by SIPCAM AGROXONE 750 Herbicide or other Group I herbicides. Since the occurrence of resistant weeds is difficult to detect prior to use, Sipcam Pacific Australia Pty Limited accepts no liability for any losses that may result from the failure of SIPCAM AGROXONE 750 Herbicide to control resistant weeds.
|Protection of wildlife, fish, crustaceans and environment
||DO NOT contaminate streams, rivers or waterways with the chemical or used containers.
|Protection of crop, native and other non-target plants
||DO NOT spray in high winds. DO NOT apply under weather conditions, or from spraying equipment, that may cause spray to drift onto nearby susceptible plants/crops, cropping lands or pastures. DO NOT allow spray drift and vapour movement onto susceptible crops such as cotton, fruit trees, legume crops, lucerne, oilseed crops, pastures, tomatoes, vegetables, vines or other sensitive crops and trees (eg Kurrajongs, Belahs, Eucalypts).
||Harmful if swallowed. Attacks eyes and will irritate the skin. When opening container, preparing spray and using prepared spray, wear cotton overalls buttoned to the neck and wrist, a washable hat, elbow length PVC gloves and goggles. If product on skin, immediately wash area with soap and water. If product or spray in eyes wash it out immediately with water. After use and before eating, drinking or smoking, wash hands, arms and face thoroughly with soap and water. After each day's use wash gloves, goggles and contaminated clothing.
||If poisoning occurs contact a doctor or Poisons Information Centre (Phone Australia: 131126). If swallowed, do NOT induce vomiting. Give a glass of water.
||Store in the closed, original container in a cool, well ventilated area. Do not store for prolonged periods in direct sunlight.
||Triple rinse containers before disposal. Add rinsings to the spray tank. Do not dispose of undiluted chemicals on site. If recycling, replace cap and return clean containers to recycler or designated collection point. If not recycling, break, crush, or puncture and deliver empty packaging to an approved waste management facility. If an approved waste management facility is not available, bury the empty packaging 500 mm below the surface in a disposal pit specifically marked and set up for this purpose, clear of waterways, desirable vegetation and tree roots, in compliance with relevant local, state or territory government regulations. Do not burn empty containers or product.
Empty contents fully into application equipment. Close all valves and return to point of supply for refill or storage.
Hand weeding should not be performed for 7 days after spraying application unless workers wear cotton overalls buttoned to the neck and wrist (or equivalent clothing), chemical resistant gloves and footwear.